forked from SimplesIP/pabx-app
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
51 lines
1.5 KiB
51 lines
1.5 KiB
; |
|
; Linux Telephony Interface |
|
; |
|
; Configuration file |
|
; |
|
[interfaces] |
|
; |
|
; Select a mode, either the phone jack provides dialtone, reads digits, |
|
; then starts PBX with the given extension (dialtone mode), or |
|
; immediately provides the PBX without reading any digits or providing |
|
; any dialtone (this is the immediate mode, the default). Also, you |
|
; can set the mode to "fxo" if you have a linejack to make it operate |
|
; properly. If you are using a Sigma Designs board you may set this to |
|
; "sig". |
|
; |
|
mode=immediate |
|
;mode=dialtone |
|
;mode=fxo |
|
;mode=sig |
|
; |
|
; You can decide which format to use by default, "g723.1", "g729", or "slinear". |
|
; Note that g729 is only supported for Sigma Designs boards. |
|
; XXX Be careful, sometimes the card causes kernel panics when running |
|
; in signed linear mode for some reason... XXX |
|
; |
|
format=slinear |
|
;format=g723.1 |
|
;format=g729 |
|
; |
|
; And set the echo cancellation to "off", "low", "medium", and "high". |
|
; This is not supported on all phones. |
|
; |
|
echocancel=medium |
|
; |
|
; You can optionally use VAD/CNG silence suppression |
|
; |
|
;silencesupression=yes |
|
; |
|
; List all devices we can use. Contexts may also be specified |
|
; |
|
;context=local |
|
; |
|
; You can set txgain and rxgain for each device in the same way as context. |
|
; If you want to change default gain value (1.0 =~ 100%) for device, simple |
|
; add txgain or rxgain line before device line. But remember, if you change |
|
; volume all cards listed below will be affected by these values. You can |
|
; use float values (1.0, 0.5, 2.0) or percentage values (100%, 150%, 50%). |
|
; |
|
;txgain=100% |
|
;rxgain=1.0 |
|
;device => /dev/phone0
|
|
|